Optocore at Glastonbury 2008
Optocore devices were used again for the digital returns system on the
Pyramid Stage at Glastonbury this year, sending multiple AES channels to
stage processors and distributing them, as well as transporting the RS485
control signal.
Andy Huffer of Optocore's UK distributor, HD Pro Audio, explained the setup,
"At FOH, the AES outputs from the Digidesign Profile console were sent to
the Optocore DD32E device, with all digital devices locked to an external
wordclock. The DD32E also received an RS485 input from an XTA DP226
processor located at FOH.
"These signals (both AES and RS485) were then sent to the Optocore DD32
device located on stage, and distributed. The AES signals were patched to
multiple outputs via the Optocore internal matrix, allowing the same signal
to be sent to multiple XTA DP226 processors where necessary - as in the case
of the main PA hangs, where one input signal was "zoned" via several DP226s.
The RS485 signal was also sent from the DD32 device to the first DP226 in
the RS485 chain on stage. Custom XLR panels were used to allow for easy
patching of all amplifier and processor racks with 4 way AES multicore
cables".
Huffer concludes, "The main advantages of using Optocore for this
application were the easy transport and distribution of multiple AES
signals, an area traditionally full of cable and wordclock issues, plus the
solid transportation of RS485 control data, which can prove unreliable over
long distances and multiple connections".
The complete system for the Pyramid Stage was supplied by Wimbledon-based RG
Jones Sound Engineering and system design was by Simon Honywill, who
commented afterwards, "The system was absolutely rock solid throughout,
Andy's co-operation and ability was total as ever and the nasty place that
is the Pyramid Stage multicore trap was significantly less crowded. I was
determined to maintain the signal in the digital domain from mic input to
loudspeaker processor output, and this was an elegant solution".